What makes gunpowder rust?

Gunpowder itself doesn't rust in the typical metal sense, but its corrosive nature comes from the fouling (residue) it leaves, which, when mixed with moisture and air, creates acidic compounds (like nitric and sulfuric acids) that eat away at metal gun barrels, leading to rust and damage over time if not cleaned properly. The key ingredients, Sulfur and Charcoal (or Black Powder), combine with water to form corrosive agents that require diligent cleaning after use to protect firearms.
Takedown request View complete answer on reddit.com

What recycles into gunpowder rust?

Recycling Items
  • Shotgun shells give more gunpowder than most ammo when recycled.
  • Smoke grenades can be bought at Outpost for 5 scrap and recycled for about 18 gunpowder plus metal fragments.
  • F1 grenades cost 8 scrap each at Bandit Camp and recycle into 15 gunpowder.
Takedown request View complete answer on rustmods.com

How corrosive is gunpowder?

You're fine as long as you clean it the same day you shoot it. Black powder itself isn't that corrosive, it's black powder fouling, when combined with moisture, that is corrosive.
Takedown request View complete answer on reddit.com

How did they keep gunpowder dry?

None of this worked very well if the black powder got wet, so it was important to keep your powder dry! Prepared cartridges were carried in a leather cartridge box and loose black powder was often carried in a hollow horn of an ox or cow, fitted with a cover and a strap to carry it.
Takedown request View complete answer on fortmifflin.us

How much sulfur is 1000 gun powder in rust?

1,000 gunpowder. equal to 2,000 sulfur and 3,000 charcoal. You will additionally need another 200 sulfur, 60 low grade, 200 metal fragments.
Takedown request View complete answer on tiktok.com

How to make Gunpowder! (& Using a Research Table) Rust for Dummies (2021 QUICK & TO THE POINT!)

Is it legal to own black powder?

A federal explosives license or permit is not required to purchase and use commercially manufactured black powder in quantities not to exceed 50 pounds for the above stated purposes in antique firearms or antique devices.
Takedown request View complete answer on atf.gov

How many 9mm bullets will 1 pound of powder make?

Here are some general estimates: 9mm Luger: Using 5 grains per round, you can load approximately 1,400 rounds from a pound of powder. . 223 Remington: With an average of 25 grains per load, expect to load around 280 rounds per pound.
Takedown request View complete answer on actiongunner.com

Is WD-40 dry lube good for guns?

Using WD-40 on guns is not recommended, as the solution can gum up the action and cause jams and malfunctions. It's best to stick with solvents and lubricants specifically designed for firearm maintenance to avoid any long-term issues and ensure your weapon will be functional when you need it most.
Takedown request View complete answer on vedderholsters.com

Can felons hunt with black powder?

Yes, felons can often hunt with black powder firearms, but it depends heavily on state law and whether the specific firearm qualifies as an "antique" under federal law, meaning it doesn't use fixed ammunition and isn't easily converted; however, some states, like Virginia, have stricter laws that still prohibit felons from possessing them, so it's crucial to check your specific state's regulations and your probation conditions. 
Takedown request View complete answer on sll.texas.gov

When did ammo stop being corrosive?

Civilian ammunition manufacturers began offering non-corrosive ammunition during the 1920s. However, most military ammunition continued to use corrosive priming mixtures. The majority of U.S. military cartridge contractors eventually made the transition to non-corrosive primers during the 1950s.
Takedown request View complete answer on usconcealedcarry.com

Can baking soda harm metal?

Yes, baking soda (sodium bicarbonate) can be mildly corrosive or damaging to certain metals, especially aluminum, gold plating, and old/antique silver, by causing discoloration or oxidation, particularly if left wet or combined with acids like vinegar; it's generally safe for stainless steel but can be too abrasive for soft metals, so rinse thoroughly and avoid prolonged contact. 
Takedown request View complete answer on forums.pelicanparts.com

Where to dispose of old gunpowder?

Gunpowder should never be thrown in the trash because it poses a significant fire hazard. For small amounts of gunpowder, it's generally safe to spread it thinly over a wide area of soil.
Takedown request View complete answer on berrysmfg.com

Where are 100% recyclers rust?

Top Rust Recycler Locations: A Comprehensive Guide
  • Abandoned Supermarket Recycler Location.
  • Airfield Recycler Locations.
  • Arctic Research Base Recycler Location.
  • Bandit Camp Recycler Location.
  • Giant Excavator Pit Recycler Location.
  • Large Harbor Recycler Location.
  • Oxum's Gas Station Recycler Location.
Takedown request View complete answer on namehero.com

What happens to gunpowder when it gets old?

Nitrocellulose gunpowder does deteriorate with time, moisture and heat, but it becomes less potent, not more.
Takedown request View complete answer on ronspomeroutdoors.com

Can a 9mm stop a grizzly bear?

However, surprisingly, with the right ammunition and good shooting, a 9mm pistol can stop a bear. Just ask Alaskan bear guide Phil Shoemaker, who had to shoot—stop—an attacking grizzly. He used Buffalo Bore's 9 mm+P Outdoorsman load that's topped with a flat-nosed, 147-grain hardcast bullet.
Takedown request View complete answer on gameandfishmag.com

Is it worth reloading 9mm in 2025?

In 2025, reloading 9mm is generally not a significant money-saver for basic practice ammo due to high component costs (primers, powder), but it's worth it for hobbyists seeking superior accuracy, custom loads (like competition ammo), controlling supply, and the rewarding experience of creating precise ammunition for a fraction of premium factory prices, especially if you collect brass. The value hinges on your goals: cost savings vs. performance/hobby satisfaction, with initial setup costs exceeding $1000 and significant time investment. 
Takedown request View complete answer on reddit.com

How heavy are 100 rounds of 9mm?

100 rounds of 9mm ammo typically weigh between 2.6 to 3 pounds (about 1.2 to 1.4 kg), depending on the bullet weight (115gr, 124gr, etc.) and packaging, with common 115-grain FMJ boxes weighing around 2.9 pounds. 
Takedown request View complete answer on reddit.com

What is the 13 yard rule for black powder?

Sighting-in a muzzleloading rifle is essential, but you can use the “13-yard rule.” You adjust the sights, or learn where to aim to hit dead-on at a target 13 yards away. When zeroed at that distance, your muzzleloader will be a bit high at 50 yards, almost right-on at 75 yards, and a little low at 100-yards.
Takedown request View complete answer on whitetailsunlimited.com

Does the ATF consider a muzzleloader a firearm?

The ATF generally considers most muzzleloaders (especially those using black powder and resembling pre-1898 designs) as antique firearms, which are excluded from federal Gun Control Act (GCA) regulations, meaning they aren't treated like modern firearms. However, if a muzzleloader can be readily converted to fire modern fixed ammunition or uses modern ignition systems like #209 primers (depending on specific GCA amendments), it can be classified as a modern firearm and subject to all federal laws. 
Takedown request View complete answer on atf.gov

Can I have a black powder pistol shipped to my house?

Old black powder pistols are not considered firearms and you can order them online to be shipped to your house. And there is no age limit on them.
Takedown request View complete answer on facebook.com

What's cheaper, C4 or rockets?

Using one rocket and one C4 is faster. and saves you about 150 sulfur. But the cheapest method is to use 1C4.
Takedown request View complete answer on tiktok.com

How much G force does a rocket take off?

Rocket launch G-forces typically range from 3 to 4.5 Gs, meaning you feel 3 to 4.5 times your normal weight, but can vary; early rockets hit over 6 Gs, while modern launches aim lower for crew comfort, with the force feeling like a heavy weight pressing you down, often described as someone sitting on your chest, peaking at stage separation before weightlessness sets in. Astronauts use G-suits and training to cope, as sustained high Gs can cause blackouts, but these launch forces are brief, allowing the body to adapt before the transition to weightlessness. 
Takedown request View complete answer on reddit.com

Previous question
What country will replace China?
Next question
Does time of day matter for fishing?